Form Solvent Nitoproof 600 Pf, UsageApplication All areas, Tensile Strength 80 8

Description performance specification liquid applied, Elastomeric waterproofing membrane where shown on the drawings shall be made of a pitch modified polyurethane. The membrane when cured shall be capable of an extension of not less than 500%. Its tensile strength shall exceed 1. 50 n/mm2and the water vapour transmissions shall be less than 10g/m2/24 hr. It shall is applicable for accordance with the methods given in the creator's data sheet. Application instructionspreparationall surfaces to be waterproofed should sound and, Be clean dry. Priming of dense concrete, Good quality is not necessary. For absorbent surfaces such as porous concrete a combination of 1 part nitoproof 600 and 1 part xylene functions to seal the surface. Bitumen and asphalt surfaces require priming with nitoproof 600 primer as an obstacle for the defense of the membrane. Nitoproof 600 primer may be utilized by brush or roller and allow to cure for 4, 8 hours after application. Do not allow primer to harden completely before proceeding with nitoproof 600 application. All movement joints should be masked and then overcoated with nitoproof 600 extending 150 mm each Alongside the tape. Shrinkage and non, Moving cracks should be pretreated with nitoproof 600 extending 75 mm either side of the crack. All critical right angle bends must have a cant strip or fillet installed prior to application of nitoproof 600. Any pretreated areas must be cured overnight before general application of the membrane. Application methods nitoproof 600 standard can be applied by brush, Squeegee, Roller or airless spray. Full details of suitable spraying tools are capable of being supplied on request. This item acts as applied at a minimum wet film thickness of 1. 3 mm. Where required, Nitoproof 600 may be reinforced using suitable fabric reinforcement. This should is well-suited for use on a 1. 3 mm application of nitoproof 600 whilst it is still wet and be overcoated with another 1. 3 mm thick application 24 hours later. The newly applied membrane must be allowed to cure for no fewer than 24 hours at 25 c. Gear and supplies should be cleaned with fosroc solvent 101 immediately after use. Limitationsnitoproof 600 should not be left exposed to uv light for more than 28 days. In situations where it will not be overlaid by a protective concrete screed, It ought to be overcoated with nitoproof reflectacoat. Some people are sensitive to resin systems. Impervious gloves and barrier cream should be used when handling these products. Eye protection should be worn. If accidental eye contamination occurs, Wash thoroughly with plenty of water and seek medical advice. If contact with it must, Skin occurs be removed before curing takes place. Wash off with an industrial skin cleaner followed by plenty of soap and water. Do not use solvent. Ensure adequate ventilation when using these products. Fireall liquid products describedon this data sheet contain flammable solvents. Do not s use near open flames orsmoke during use